Bad Boys Traffic Film Remover | Pre-wash agent (5 L)

Remove road grime before contact washing

Layers of grime accumulated over several days, greasy road film, and traffic dirt can be a real challenge for regular active foam. RRCustoms Bad Boys Traffic Film Remover is an extremely strong alkaline concentrate for contactless pre-washing that helps loosen stubborn dirt before the wash mitt ever touches the paint.

Thanks to a dilution range from 1:10 to 1:100, you can easily adapt the cleaning power to the current level of soiling. When used correctly, you get a more effective pre-wash, less dirt on the paint, and a safer subsequent hand wash.

RRCUSTOMS BAD BOYS TRAFFIC FILM REMOVER AT A GLANCE

• Dissolves road film, grease, and stubborn traffic grime.
• Highly concentrated formula with dilution options up to 1:100.
• Contactless pre-wash reduces the amount of dirt during hand washing.

When active foam alone is not enough

Traffic Film Remover is used as the first cleaning step before active foam or contact washing. The highly alkaline formula penetrates greasy layers and helps loosen dirt from paint, plastics, glass, rubber parts, sills, wheel arches, and the engine bay.

It can also be used for cleaning the engine compartment and other heavily soiled areas. The less dirt remains on the surface before hand washing, the lower the risk of spreading it across the paintwork.

Performance you can adapt to the level of dirt

For standard pre-washing, we recommend a dilution of approximately 1:20. You can use a stronger mixture for heavily soiled parts, while a higher dilution is suitable for regular maintenance or more sensitive protective layers.

When diluted higher than 1:20, the product is also suitable for ceramic coatings and durable synthetic waxes. However, a solution that is too strong can weaken wax protection, so always adjust the concentration according to the type of surface and the level of soiling.

Instructions for use

1. Shake the bottle before use.
2. Dilute the concentrate with water in a ratio of 1:10 to 1:100; for standard use, approximately 1:20.
3. First, rinse the vehicle with high-pressure water to remove loose dirt.
4. Apply the solution starting from the bottom of the vehicle upwards.
5. Leave to act for a maximum of 5 minutes and do not let it dry.
6. Rinse the surface thoroughly with high-pressure water and proceed with contact washing.

Important notice

This is a highly alkaline concentrate with a pH of 14 that must always be properly diluted before use. Do not work on a hot surface or in direct sunlight, and test the product on an inconspicuous area before the first application.