Bad Boys Traffic Film Remover | Pre-wash agent (500 ml)

Road grime off before contact washing

Layers of grime accumulated over several days, greasy road film, and traffic dirt can be a real challenge for regular active foam. RRCustoms Bad Boys Traffic Film Remover is an extremely strong alkaline concentrate for contactless pre-washing that helps loosen stubborn dirt before the wash mitt even touches the paintwork.

Thanks to the dilution range from 1:10 to 1:100, you can easily adjust the cleaning power to the current level of contamination. When used correctly, you will achieve a more effective pre-wash, less dirt on the paint, and a safer subsequent hand wash.

RRCUSTOMS BAD BOYS TRAFFIC FILM REMOVER AT A GLANCE

• Dissolves road film, grease, and stubborn traffic deposits.
• Highly concentrated formula with dilution options up to 1:100.
• Contactless pre-wash reduces the amount of dirt during hand washing.

When active foam alone isn't enough

Traffic Film Remover is used as the first cleaning step before active foam or contact washing. The highly alkaline formula penetrates greasy deposits and helps loosen dirt from paint, plastics, glass, rubber parts, sills, wheel arches, and the engine bay.

It can also be used for cleaning the engine bay and other heavily soiled areas. The less dirt remains on the surface before hand washing, the lower the risk of dragging it across the paintwork.

Performance you can adapt to the level of dirt

For regular pre-washing, we recommend a dilution of approximately 1:20. A stronger mixture can be used on heavily soiled areas, while higher dilution is suitable for regular maintenance or more sensitive protective layers.

When diluted more than 1:20, the product is also suitable for ceramic coatings and durable synthetic waxes. However, an overly strong solution can weaken wax protection, so always adjust the concentration to the surface type and the degree of soiling.

Instructions for use

1. Shake the bottle before use.
2. Dilute the concentrate with water in a ratio of 1:10 to 1:100; for regular use, approximately 1:20.
3. First, rinse the vehicle with pressurized water to remove loose dirt.
4. Apply the solution from the bottom of the vehicle upwards.
5. Leave to work for a maximum of 5 minutes and do not let it dry.
6. Rinse the surface thoroughly with pressurized water and proceed to contact washing.

Important notice

This is a highly alkaline concentrate with pH 14 that must always be properly diluted before use. Do not work on hot surfaces or in direct sunlight, and test the product on an inconspicuous area before the first application.